Accredited extraction for lofts, roofs and cavity walls across Staffordshire
Closed cell spray foam removal in Stafford done right the first time
If you need closed cell spray foam removal in Stafford, our team cuts out rigid polyurethane foam from lofts, roof decks and cavity walls without wrecking the timbers underneath. We handle mortgage-lender-flagged properties, damp lofts and botched DIY spray jobs across Stafford and Staffordshire. Most lofts are cleared in a single day, with the waste bagged, the vacuum-filtered air scrubbed, and the roof space left ready for breathable insulation. Call 03335672543 for a same-day assessment.
Live phone supportUpfront optionsBacked workmanship
What's included
What our closed cell spray foam removal includes
Every Stafford job includes the survey, the dust-controlled extraction, the waste removal and the completion report. We do not sub-contract the cutting, and we do not leave you to dispose of the foam yourself. Here is exactly what is covered in a standard quote.
Free on-site survey
We attend your Stafford property, map the foam with a thermal imaging camera, check for damp with a moisture meter, and identify the foam brand where possible. You get a fixed written price the same day.
Dust-controlled extraction
Protective sheeting, an air scrubber and a HEPA spray foam removal vacuum are set up before cutting starts. Operatives wear respirators because cured foam releases isocyanate dust when cut.
Full waste removal
All foam, dust and debris is bagged and removed from site. We separate the waste for responsible disposal and leave your loft or roof void swept clean, ready for new insulation.
Timber and felt inspection
As the foam comes out we check rafters, trusses and felt for rot or damage. Any issues are photographed and reported the same day, with a separate quote if carpentry work is needed.
Completion report
You receive a written report with dated photographs and moisture readings, suitable for a mortgage lender, surveyor or building control. It confirms the foam is gone and the roof structure is sound.
Service overview
What closed cell spray foam removal in Stafford actually involves
closed cell spray foam removal in Stafford is a controlled demolition and extraction service that cuts cured polyurethane foam out of roof spaces, rafters, cavity walls and floor voids, then restores the structure so it can breathe again. Closed cell foam sets rock-hard at roughly 2 lb per cubic foot, so it cannot be scraped off like open cell spray foam. We slice it into manageable blocks with an oscillating multi-tool, prise it free with an industrial scraper, and vacuum the debris through a HEPA-filtered spray foam removal vacuum. Every operative wears a respirator because cured foam still releases isocyanate dust when cut.
Stafford homeowners usually call us for one of three reasons: a mortgage lender has flagged spray foam in the roof, a loft conversion has been refused because ventilation was blocked, or hidden damp has started rotting the roof timbers under the foam. We also get called to Baswich and Wildwood after DIY spray foam kits have expanded into eaves and cables. Because we are based locally, we can survey a Stafford property within 24 hours and give you a fixed price before any cutting starts.
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.
The service timeline
How our closed cell foam extraction process works
The process flexes to the condition, but these checkpoints keep decisions clear.
Survey and quote
We attend your Stafford property, usually within 24 hours of your call. Using a thermal imaging camera and moisture meter, we map the foam depth, check for hidden damp and inspect the roof timbers. You get a fixed written price the same day, with no charge for the survey.
Contain the work area
Before any cutting starts, we lay protective sheeting across floors, stairwells and loft hatches, then set up an air scrubber to capture airborne dust. Cured closed cell foam releases isocyanate particles when cut, so containment is not optional. This stage takes 30 to 45 minutes on a typical Stafford semi.
Cut and extract the foam
Our technicians slice the foam into blocks with an oscillating multi-tool, prise it away from rafters with an industrial scraper, and feed the waste into a spray foam removal vacuum. On a standard 8m by 5m loft, expect four to six hours of cutting. We work in sections so the roof structure is never left exposed overnight.
Clean and inspect
Once the bulk is out, we hand-finish around nails, cables and trusses, then vacuum every surface. A moisture meter reading confirms whether the timbers are dry or need further drying. If we find rot, we tell you the same day and quote for a carpenter to sister the affected rafters.
Report and hand back
We photograph the cleared roof space, note the condition of the felt and timbers, and issue a completion report suitable for a mortgage lender or building control. The loft is left swept, the waste removed, and the space ready for new breathable insulation. Most Stafford jobs finish within one working day.
Tools & methods
Tools and methods we use for foam extraction
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Oscillating multi-tool
Cuts cured closed cell foam into blocks without shock-loading the rafters. It reaches into eaves and around cables where a saw will not fit.
Industrial scraper
Prise the cut blocks away from timber and felt once the multi-tool has released the edges. Used with care to avoid tearing the roof felt underneath.
Spray foam removal vacuum
HEPA-filtered extraction that captures foam dust and isocyanate particles at the cutting face, keeping the rest of the house usable while we work.
Dry ice blasting machine
Removes foam residue bonded to brick, stone or metal decking without grit or water, which matters on heritage buildings and plant rooms.
Sand blasting equipment
Strips the last traces of foam from masonry and steel after the bulk is cut away. Media is contained and cleaned up before hand-back.
Thermal imaging camera
Finds hidden foam, cold bridging and damp patches behind boards and in corners during the survey, so the quote covers the whole job.
Moisture meter
Confirms whether roof timbers are dry after extraction, and flags hidden damp that needs drying before new insulation goes in.
Use cases
When Stafford homeowners need closed cell foam extraction
These examples show how the service framework adapts rather than forcing every call through one repair.
Wildwood loft conversion unblocked
A family in Wildwood wanted to convert their loft but closed cell foam covered the rafters and blocked the roof deck. Building control would not approve the conversion with the foam in place. → We cut and extracted 42 square metres of foam over two days, inspected the timbers, and left the rafters clean and ready. Breathable insulation was fitted afterwards and the conversion passed building control.
Town centre terrace damp stopped
A landlord in Stafford Town Centre had damp staining on the ceiling below a foam-filled roof. The foam had sealed the deck and blocked the eaves, and two rafters had started to soften. → We removed the foam, dried the timbers with air movers, and restored ventilation. The two soft rafters were sistered by a carpenter. Moisture readings dropped from 24% to 14% within ten days.
Problems we solve
Problems our closed cell spray foam removal in Stafford solves
Closed cell foam is sold as a permanent fix, but in Stafford's older housing stock it often creates more problems than it solves. These are the issues we are called out to most often, and how we put them right.
Mortgage lender refuses to lend on a foam-filled roof
We remove the foam, photograph the exposed rafters and felt, and issue a completion report your lender will accept. Most Stafford sales we deal with are back on track within two to three weeks of the survey.
Hidden damp rotting roof timbers
We cut the foam out, dry the timbers with air movers, and restore the eaves ventilation. A moisture meter reading confirms whether the structure is dry before we hand back. Any rot is reported and quoted for separately.
Loft conversion blocked by rigid foam
Extraction clears the rafters and roof deck so a conversion can proceed. We leave the space ready for breathable insulation that meets current ventilation standards, and we can work to your builder's programme.
Blocked eaves vents and poor airflow
We clear the foam from the eaves, check the vents are open, and confirm a 50mm airflow gap is present. The roof space then dries naturally instead of holding moisture against the timbers.
Pricing process
What closed cell spray foam removal costs
£1,200 - £4,500 depending on scope
Square metreage
Foam is priced by area, not by the hour. A standard 8m by 5m loft is around 40 square metres and sits at the lower end. Larger roof decks and warehouses scale up accordingly.
Foam thickness and density
Closed cell foam is denser than open cell and takes longer to cut. Foam over 100mm thick, or foam that has expanded around cables and trusses, adds labour time to the job.
Access and working height
A loft with a fixed hatch and clear floor is quick to work in. Restricted hatches, low pitches and roofs needing tower access add time and equipment, which affects the price.
How much does closed cell spray foam removal cost in Stafford?
Most Stafford lofts cost between £1,200 and £2,800 in 2026, with larger roof decks or cavity wall jobs running to £4,500. Price depends on foam thickness, the square metreage, access, and whether the timbers need drying. We survey free, quote in writing, and the price does not change unless you add work.
Can you remove closed cell foam in Stafford?
Yes. We remove closed cell foam across Stafford and Staffordshire, including lofts, roof decks, cavity walls and commercial units. Closed cell foam is denser than open cell, so we cut it with an oscillating multi-tool and industrial scraper rather than pulling it by hand. A standard 8m by 5m loft takes one working day.
Is closed cell foam extraction available in Staffordshire?
Yes. We cover the whole of Staffordshire from our Stafford base, including Baswich, Wildwood, Weeping Cross, Rising Brook and out to Derrington and Walton-on-the-Hill. Travel within 15 miles of Stafford is included in the quoted price. For larger commercial roofs we travel further across the county.
Will removing spray foam damage my roof?
Not when it is done properly. We cut the foam away from the rafters and felt rather than tearing it, and we inspect the timbers as we go. If we find rot or damaged felt, we tell you the same day and quote separately for a carpenter. The roof structure is never left exposed overnight.
Related services
Related Services
Spray Foam Removal near me
If you are searching for spray foam removal near me in Stafford, we cover the whole town and surrounding villages. Same equipment, same dust controls, same fixed pricing whether you are in Baswich or Burton Manor.
same day Spray Foam Removal
We keep slots open for urgent Stafford jobs, including lender deadlines and pre-sale surveys. Call before 10am and we can often survey the same day and start extraction within 48 hours.
24/7 Spray Foam Removal
For commercial clients in Stafford with water ingress or emergency roof access issues, we run an out-of-hours line. Call 03335672543 and we will arrange a site visit around your operating hours.Ready when you are
Book closed cell spray foam removal in Stafford today
If a lender has flagged your roof or you have found damp under the foam, call us now on 03335672543. We survey free, quote in writing, and carry the dust controls and accreditation to do the job properly. Same-day surveys available across Stafford.
Talk with the local team
Request closed cell spray foam removal
Ring 0333 567 2543 any time, day or night, and you will speak to someone who knows Stafford roofs. For non-urgent jobs, email us a photo of the foam and we will come back with a survey slot, usually within one working day. We cover the whole of Stafford and Staffordshire.